I'm in the process of changing my rear brake back
to drum-round swingarm from disc-square swingarm. Ive got the
proper steel brake lines and tee fitting. Question is what does
the tee fitting bolt to? Ive looked at all the pix I can find
but cant find a good enough closeup to see where the tee bolts
up.
Post by panfreak on Aug 22, 2005, 6:02am
Hey Pete,
I wasn't clear on the stock location either, but I attached it to front left
trans plate mounting bolt. This tucked it neatly out of site behind the inner
primary, and was in line with my brake light wire routing. Works for me.... hope
this helps. Oh yah, I also had to bend the tab on my tee so that it was 90' to
the tee body, this put it in an upright position which made it fit nicely. Some
I think come that way, but mine required some personal modification to mount
it in this location due to clearance issues with the primary and rear chain.
Post by RussW on Aug 22, 2005, 6:17am
As I remember, the tee bolted to a bracket on the frame in front of the primary
cover, behind the kick stand bracket.
Post by 1962wild1 on Aug 23, 2005, 12:18pm
I have my 62 torn down if you would like a picture. It is fairly clear and shows
the location.
leon
