Springer lock plate

Knucklehead topics
Post Reply
white1j0
Posts: 175
Joined: Mon Apr 09, 2012 7:38 pm
Bikes: '02 Fatboy, '47 Knuckle, '52Pan

Springer lock plate

#1

Post by white1j0 » Sat Jul 15, 2017 8:07 pm

I have two '47 Knuckles' one is complete and has an after market set of Hollywood handlebars,the lock plate has the locking pin in the front position the other I'm in the process of building I'm putting on a set of stock bars which has the locking pin in the rear position, is this normal



Lowbikemike
Posts: 145
Joined: Thu May 07, 2009 3:49 am
Bikes: 1962 FL
1987 FXSTC
1995 FLHR
Location: Columbia, IL

Re: Springer lock plate

#2

Post by Lowbikemike » Sat Jul 15, 2017 11:46 pm

I'm not sure but while you are talking lock plates and pins.........how is the pin removed? I have a inline plate with the pin installed and an offset plate with no pin. Id like to put the pin in the offset plate. Is the center pin pressed into the larger piece below the plate or screwed in? Any thoughts.

RUBONE
Moderator
Posts: 4474
Joined: Sat Nov 15, 2008 4:09 am
Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...

Re: Springer lock plate

#3

Post by RUBONE » Sat Jul 15, 2017 11:56 pm

The pins are riveted to the plates.

Lowbikemike
Posts: 145
Joined: Thu May 07, 2009 3:49 am
Bikes: 1962 FL
1987 FXSTC
1995 FLHR
Location: Columbia, IL

Re: Springer lock plate

#4

Post by Lowbikemike » Sun Jul 16, 2017 4:01 pm

Thanks for the reply.

Post Reply

Return to “Knucklehead”

Who is online

Users browsing this forum: No registered users and 4 guests