Bestway 5SPCH

All other topics
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
VintageTwin
Panhead Register Member
Posts: 776
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Been thanked: 1 time

Bestway 5SPCH

#1

Post by VintageTwin » Sat Apr 02, 2005 12:51 am

The rear 2x4x14" support for OHV Big Twins has two 2-1/4" holes core-drilled for rigid and swing arm transmission stud access. Align the 2x4 with the edge of the ramp where yellow corner marks are.
That half-moon hole on the left side of the 2x4 needs the top edge widened back (fluted like, ya' know?) or you can't fit a socket extension up to tighten the right rear trans stud on a rigid frame Big Twin. Also that front 2x4 needs a 6" section cut-down in the middle for skid-pan clearance on a rigid frame. I'm altering mine with the blade depth set on a table saw and making a bunch of relief passes so I can knock out the kerfs like it was routed.
You do not have the required permissions to view the files attached to this post.
Last edited by Anonymous on Mon Nov 14, 2005 3:55 pm, edited 12 times in total.



Post Reply

Return to “General/Miscellaneous topics”