1957 & 1959 Fenders

Post Reply
VintageTwin
Panhead Register Member
Posts: 778
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Been thanked: 1 time

1957 & 1959 Fenders

#1

Post by VintageTwin » Wed Mar 31, 2004 1:18 am

The gray fender '57 was advertised as USA from V-Twin 6 yrs. ago. All the braces are supported by a second plate underneath. OE to me.
The '59 fender is new from Taiwan-V-Twin. Same construction. Nice work. The nut that is tacked looks like a cold weld, but it isn't. Each nut is fastened by two tacked places.
You do not have the required permissions to view the files attached to this post.
Last edited by Anonymous on Wed Mar 31, 2004 3:15 pm, edited 2 times in total.



VintageTwin
Panhead Register Member
Posts: 778
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Been thanked: 1 time

#2

Post by VintageTwin » Wed Mar 31, 2004 1:21 am

Another '59 and then the gray '57.
You do not have the required permissions to view the files attached to this post.
Last edited by Anonymous on Wed Mar 31, 2004 1:27 am, edited 1 time in total.

VintageTwin
Panhead Register Member
Posts: 778
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Been thanked: 1 time

#3

Post by VintageTwin » Wed Mar 31, 2004 1:25 am

The inside of the '57
You do not have the required permissions to view the files attached to this post.

VintageTwin
Panhead Register Member
Posts: 778
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Been thanked: 1 time

Fender Tips '49-57 & '58-up

#4

Post by VintageTwin » Mon Sep 13, 2004 4:13 am

Here's the approx. measurements tip and side trim for the front fender.
You do not have the required permissions to view the files attached to this post.

Panhead Joey
Posts: 47
Joined: Sun Nov 08, 2015 10:46 pm
Bikes: Harley Davidson 1959 FL Panhead 1964 FLH
Location: Irvine CA
Been thanked: 1 time

Re: 1957 & 1959 Fenders

#5

Post by Panhead Joey » Mon May 15, 2017 9:53 am

Hi,

I have a 1959 FL PANHEAD and want to repaint the rear fender do I have to remove the rear wheel to remove the fender? If so, are there any other suggestions or tips I would need to know while removing the rear wheel?

Thanks for any advice or help.

PANHEAD joey

Post Reply

Return to “Fenders, Primary, Tanks & Paint”