Tool Box and Mount

Chassis, frame, instruments, fenders etc.
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
51Hog
Posts: 655
Joined: Fri May 20, 2005 7:29 pm
Location: Wasilla, Alaska

Tool Box and Mount

#1

Post by 51Hog » Wed Apr 09, 2008 1:57 am

Is this the correct tool box for the mount on this frame?
Is it right for a 51 FL?
I had it mounted, and vibrations fatigued the box parallel to the doubler that is up against the mount.
The lid is without ribs.
Thanks
You do not have the required permissions to view the files attached to this post.



Robert Luland
Posts: 888
Joined: Sun Sep 02, 2007 7:56 pm
Bikes: 1922JD, 1937 ULH, 1946FL 1948FL, 1957FL, 1960FLH, 1965XLCH, 1995 FLHT
Location: Hoboken, NJ
Contact:

#2

Post by Robert Luland » Wed Apr 09, 2008 9:43 pm

It will fit any big twin but is not correct for 51. 58-64 is smooth cover. Bob

51Hog
Posts: 655
Joined: Fri May 20, 2005 7:29 pm
Location: Wasilla, Alaska

#3

Post by 51Hog » Mon Apr 14, 2008 4:42 pm

Thanks for the reply Robert.
My rear fender is drilled for the spacer. I think I will drill the box after welding the crack that runs full length of the doubler and install the spacer. Maybe it won't crack again.

Post Reply

Return to “Chassis, Frame & Instruments”