looking for filler rod suggestions

Chassis, frame, instruments, fenders etc.
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
Bill Golightly
Posts: 16
Joined: Tue Jun 14, 2005 1:16 am
Bikes: rigid frame '62 Pan
'09 cvo road glide
Location: Stone Mountain, Georgia

looking for filler rod suggestions

#1

Post by Bill Golightly » Tue Jul 19, 2005 10:39 pm

I am putting early juice rear brakes on a '54 V-Twin frame. As you know, a tab is required to locate the backing plate anchor. Can anyone suggest a filler rod to use to tig that tab in place? I can not seem to find out what the casting is.
Thank you,
Bill



mbskeam
Posts: 964
Joined: Tue Mar 16, 2004 5:52 am
Location: Sultan, WASH
Contact:

#2

Post by mbskeam » Wed Jul 20, 2005 4:18 am

hello,
when I redid my frame years ago,I used rod #ER70S-2 on the root weld(TIG) and then went back over it with the wire feed. to match other welds
almost 15 years latter and no problems.
mbskeam

Post Reply

Return to “Chassis, Frame & Instruments”