Timer control wire routing

Chassis, frame, instruments, fenders etc.
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
DanM
Posts: 30
Joined: Mon Mar 07, 2005 2:57 am
Location: Salem, NH

Timer control wire routing

#1

Post by DanM » Sat May 15, 2004 4:00 am

Description: What is proper routing?

Hi all:

Still getting the 64 back together. Could use advice on proper routing of the timer control coil. Since I got the bike, it has been getting caught between the frame and tree stop. What is proper routing? On the front frame guard mount there is a tapped hole. Should there be a clip there? Does it route between the front frame rails or around the left down tubel, between the head and frame, then down to the clamp? Should there be a clamp around a frame rail? I can't tell from the parts book. I appreciate all the advise I've gotten so far! Thanks!



DuoDave
Posts: 198
Joined: Tue Mar 16, 2004 10:45 pm

Re: Timer control wire routing

#2

Post by DuoDave » Sat May 15, 2004 11:05 am

The control coil goes around the left down tube and there should be a securing clip screwed into that tapped hole. It's the same type of clip that holds the throttle coil under the gas tanks.
My timer control coil also gets trapped on full lock!

Post Reply

Return to “Chassis, Frame & Instruments”