Rear stand catch hole spacing

Chassis, frame, instruments, fenders etc.
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
Panshovevo
Posts: 293
Joined: Sun Jul 25, 2010 5:18 pm
Bikes: '50 F model, '76FX/L, '96 96" FXDWG
Location: SE Florida
Contact:

Rear stand catch hole spacing

#1

Post by Panshovevo » Wed Jul 28, 2010 2:25 am

I'm about to paint a repop rear fender for the '50, and want to drill the holes for the mounting screws for the rear stand catch (which will be here next week) before painting.I suspect that the upper screw uses the same hole as the lower screw of the taillight, and have seen the dimensioned pic in the knowledge base, but would like to know the center to center distance to be sure.
Can anyone help?
TIA,
John



Panshovevo
Posts: 293
Joined: Sun Jul 25, 2010 5:18 pm
Bikes: '50 F model, '76FX/L, '96 96" FXDWG
Location: SE Florida
Contact:

Re: Rear stand catch hole spacing

#2

Post by Panshovevo » Fri Jul 30, 2010 5:04 am

Anyone???
Can anyone with a rigid frame pan, with the rear stand installed, measure the distance between the two screws that hold the stand catch to the fender?
Or if you happen to have a fender or rear stand catch handy, could you measure the distance between the holes?
It would be greatly appreciated.
John

john HD
Moderator
Posts: 3661
Joined: Sat Aug 20, 2005 7:24 pm
Bikes: '42 WLA X 2, '55FL, '93 Ultra Classic, '91 Fatboy, '97 883, '71 Suzuki Duster 125, '83 GPz 750.

Re: Rear stand catch hole spacing

#3

Post by john HD » Fri Jul 30, 2010 6:36 am

will this help? note, the measurements are to the top of the holes measured from the notch for the hinge.

john
You do not have the required permissions to view the files attached to this post.

Panshovevo
Posts: 293
Joined: Sun Jul 25, 2010 5:18 pm
Bikes: '50 F model, '76FX/L, '96 96" FXDWG
Location: SE Florida
Contact:

Re: Rear stand catch hole spacing

#4

Post by Panshovevo » Sat Jul 31, 2010 3:54 am

thanks John, much appreciated
John

Panshovevo
Posts: 293
Joined: Sun Jul 25, 2010 5:18 pm
Bikes: '50 F model, '76FX/L, '96 96" FXDWG
Location: SE Florida
Contact:

Re: Rear stand catch hole spacing

#5

Post by Panshovevo » Mon Aug 02, 2010 2:57 pm

John,
Were those measurements taken from the inside or outside of the fender?
John

john HD
Moderator
Posts: 3661
Joined: Sat Aug 20, 2005 7:24 pm
Bikes: '42 WLA X 2, '55FL, '93 Ultra Classic, '91 Fatboy, '97 883, '71 Suzuki Duster 125, '83 GPz 750.

Re: Rear stand catch hole spacing

#6

Post by john HD » Mon Aug 02, 2010 10:49 pm

outside.

john

Post Reply

Return to “Chassis, Frame & Instruments”