Panhead Neck Cups

Post Reply
hibuck1
Posts: 225
Joined: Sat Sep 11, 2010 10:10 pm
Bikes: 55 pan
Location: ohio
Been thanked: 1 time

Panhead Neck Cups

#1

Post by hibuck1 » Fri Sep 17, 2010 3:14 pm

how can you tell the right neck cups compared to knucklehead or later pan or shovel for 55 pan I know 49 and later use 48300-49 timken bearings but would like to know what the cups look like for 55 pan and what years do the fit? thxs for any insight



Robert Luland
Posts: 899
Joined: Sun Sep 02, 2007 7:56 pm
Bikes: 1922JD, 1937 ULH, 1946FL 1948FL, 1957FL, 1960FLH, 1965XLCH, 1995 FLHT
Location: Hoboken, NJ
Been thanked: 36 times
Contact:

Re: Panhead Neck Cups

#2

Post by Robert Luland » Fri Sep 17, 2010 8:31 pm

hibuck1 wrote:how can you tell the right neck cups compared to knucklehead or later pan or shovel for 55 pan I know 49 and later use 48300-49 timken bearings but would like to know what the cups look like for 55 pan and what years do the fit? thxs for any insight
You can’t tell with out a caliber. Earlier and later cups are identical. The only difference being the race. The earlier cups take a Timken 07196 race and 07100 bearing. The later cup takes a Timken L44610 race and a L44643 bearing (Buy them at your local bearing suppy). The earlier race has a smaller OD than the later. The later race will not fit in the earlier cup but the early race will fit in the later cup loosely. Be careful. If I remember correctly the earlier race and bearing are higher, so if you’re going to run tins you got to have them or the triple tree mounting holes won’t line up. Mark Blankenship remakes the earlier cups if you need them. I can’t find his number here but I’m sure some one here has it. Bob L
Last edited by Robert Luland on Sat Sep 18, 2010 12:17 pm, edited 2 times in total.

Panacea
Posts: 1864
Joined: Fri May 24, 2002 1:00 am
Bikes: 64FL 99FLHR 01FXSTD
Location: Mpls. MN.
Has thanked: 14 times
Been thanked: 57 times

Re: Panhead Neck Cups

#3

Post by Panacea » Sat Sep 18, 2010 3:54 am

Mark Blankenship,(304)697-1445 49-59 cups custom made for 16 roller timkens and races, not 60 up 19 roller which is what every one else sells...Mike

hibuck1
Posts: 225
Joined: Sat Sep 11, 2010 10:10 pm
Bikes: 55 pan
Location: ohio
Been thanked: 1 time

Re: Panhead Neck Cups

#4

Post by hibuck1 » Sun Sep 19, 2010 2:52 am

great thxs i will call him

Post Reply

Return to “Frame & Fittings”