Wiring Harness For '59-64 & Vintage Twin "Hollister

Electrical issues
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
VintageTwin
Panhead Register Member
Posts: 618
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell

Wiring Harness For '59-64 & Vintage Twin "Hollister

#1

Post by VintageTwin » Sun Oct 10, 2004 3:41 am

These is the main wiring harness for the voltage regulator '36-59 Big Twin. It is not a typical '59 harness. It's used for '59 w/ neutral lamp, rachet-top, jockey shift configured Knuckles & Pans.
You do not have the required permissions to view the files attached to this post.
Last edited by Anonymous on Wed Feb 16, 2005 2:58 pm, edited 5 times in total.



VintageTwin
Panhead Register Member
Posts: 618
Joined: Mon Aug 16, 2010 7:18 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell

#2

Post by VintageTwin » Sun Oct 10, 2004 3:45 am

Three wires leave the loom . One goes to the timer (C.B.), and the F and A wires to the generator terminals. On the coil end of the harness, the wires are labeled C.B. from the primary (front) side of the coil, across from that is the secondary coil wire to the dash. Below that is the neutral switch wire to the rachet top, and the two brake switch wires at the bottom.
You do not have the required permissions to view the files attached to this post.

Post Reply

Return to “Electrical”