wiring on genarator end regulator

Electrical issues
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
Dougy
Posts: 6
Joined: Mon Aug 27, 2007 5:15 pm
Bikes: 1958 panhead chopper
Location: Scotland

wiring on genarator end regulator

#1

Post by Dougy » Wed Sep 19, 2007 5:36 pm

could any of you guys tell me whare the wires go of the regulator on to the genarator. IT is a cycle electric 12 volt 2 brush does not seem to be any info on cycle electric web site for this colour of wires, do any of you guys have one the same if so can you give me some info.thanks Doug
You do not have the required permissions to view the files attached to this post.



Skip
Posts: 231
Joined: Mon Apr 26, 2004 11:18 pm
Bikes: 48 pan
81 shovel
01 softail std
04 heritage
08 roadking
72 ct70
Location: WV

#2

Post by Skip » Wed Sep 19, 2007 7:19 pm

Normally it would be...on a 6V system....Brown wire to "A" and the green wire to "F"....then run a 14G wire from the "B" terminal to the Battery....be sure to polarize by touching a wire from the "B" to the "A"......hope that helps....if not try cycleelectircinc.com.....under installation instructions........Skip

Post Reply

Return to “Electrical”