The Panhead & Flathead Site

Post by demoman on Apr 19, 2004, 1:03am

Just started tearing apart my new to me 64 Duo Glide. At some point in time it has been rewired, I can only find the one terminal board behind the headlight. I thought according to the wiring diagram there is supposed to be two. Where is the second one supposed to be?

Thanks for the help

Steve

Post by Weez on Apr 19, 2004, 1:37am

I believe on 64 its behind the coil. On the down/seat post.

Post by billy on Apr 19, 2004, 1:42am

That is Exactly where it is. My 63 was there also. ;D
I miss that one.. :'(

Post by snake33 on Apr 19, 2004, 5:16pm

Yep...my 1965 is there also. Unfortunately, I was just in there last week.....but it is all good now.

Post by Weez on Apr 24, 2004, 8:42am

I had to completely wire my Shovel couple years ago and it was all because of a wire tip/connector on the termial board behind the coil that was shorting out. I couldn't track it down So decided to wire the bike and found that board/problem when doing the job. It is a dresser and loaded with stuff So to find the culprit that was shorting the bike out was a task. But now It would be the first place I would look if faced with the problem, with the stock type wire harness....................