Thanks for post feature available again: viewtopic.php?f=7&t=17581

Timer wire route

Electrical issues
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
mogman
Posts: 103
Joined: Sun Oct 01, 2006 4:29 pm

Timer wire route

#1

Post by mogman » Wed Mar 19, 2008 10:03 pm

I hate to start another thread, I added this question to the 60 wire routing thread but no one responded.
Can someone look and describe the wire route for the timer wire to coil?
Thanks
Craig



VPH-D
Posts: 854
Joined: Tue Feb 01, 2005 1:00 am
Been thanked: 57 times

#2

Post by VPH-D » Mon Mar 24, 2008 7:50 pm

Doesn't the dual point wire follow the same route as a single point? Behind
the tappet blocks, held in place by the clamp on the crankcase stud below the right rear base nut.
VPH-D

mogman
Posts: 103
Joined: Sun Oct 01, 2006 4:29 pm

#3

Post by mogman » Thu Mar 27, 2008 12:55 am

VPH-D You are correct! I did find a picture that showed it routed just as you described. I'm not sure how to start a K.B. on this subject, but I'm sure there would be allot of folks that could add info about wire routing.
Craig

wrecks74

timer wire

#4

Post by wrecks74 » Thu Mar 27, 2008 9:30 pm

on my 59 pan, the wire runs over the gen, along the left side of the engine just above the timeing hole/plug. along side with the speedo cable and up to the coil.

pandit
Posts: 11
Joined: Mon Jul 16, 2007 2:43 pm

#5

Post by pandit » Thu Mar 27, 2008 10:34 pm

Image

and

Image

Robert Luland
Posts: 898
Joined: Sun Sep 02, 2007 7:56 pm
Bikes: 1922JD, 1937 ULH, 1946FL 1948FL, 1957FL, 1960FLH, 1965XLCH, 1995 FLHT
Location: Hoboken, NJ
Been thanked: 36 times
Contact:

#6

Post by Robert Luland » Thu Mar 27, 2008 11:10 pm

60 have no duel point. 61-up. Bob

Post Reply

Return to “Electrical”