need help tracing my wiring routes.

Electrical issues
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
neilw
Site sponsor
Site sponsor
Posts: 248
Joined: Sat Dec 20, 2008 3:24 am
Bikes: 1995 Roadking(still brand new)
1991 HD springer
1959 pan (I'm reassembling)
Location: Calgary
Been thanked: 2 times

need help tracing my wiring routes.

#1

Post by neilw » Sun Feb 22, 2009 9:28 pm

I'm attaching a photo of Harleys wiring diagram for a 59 FLH . Can some one help me with the exact route the circuit breaker to coil wire goes ( does it pass between the cylinders)?Also loom "L" gen.to vlt.reg.
Loom "C" and loom"A" have a lot of wires comming into the instrument panel base plate area .Some wires mount on the top of the base plate ,others go below to connections .Since my base plate has 3 holes with nothing to go in them I'm wondering if some of the wiring comes up through these holes ,or do they just come in the rear of the base plate over the top of it.
Also loom "N" from the oil sending switch to the light ,I'm not sure where that runs either.
Thanks ,Neil
You do not have the required permissions to view the files attached to this post.



john HD
Moderator
Posts: 3677
Joined: Sat Aug 20, 2005 7:24 pm
Bikes: '42 WLA X 2, '55FL, '93 Ultra Classic, '91 Fatboy, '97 883, '71 Suzuki Duster 125, '83 GPz 750.
Has thanked: 52 times
Been thanked: 77 times

Re: need help tracing my wiring routes.

#2

Post by john HD » Sun Feb 22, 2009 10:13 pm

neil

yes the 3 looms go through the holes in the speedo plate. i believe dave swanson just posted a very good pic of his '56.

the timer wires run down the seat post to the right side of the motor behind the pushrods. there is a clip on the top rear case bolt. (with a clip on the seat tube with loom "n")

the gen/reg wires run down the left front frame down tube with two clips and go to the gen and on to regulator.

loom n as you call it goes from the junction box behind the coil down the seat post tube to the oil sender and stop switch. this is held in place with a clip on the seat tube with the timer wire.

john

mbskeam
Posts: 1006
Joined: Tue Mar 16, 2004 5:52 am
Location: Sultan, WASH
Been thanked: 2 times
Contact:

Re: need help tracing my wiring routes.

#3

Post by mbskeam » Mon Feb 23, 2009 1:05 am

DSC_0349.jpg
DSC_0358.jpg
DSC_0360.jpg
view of box under coil top side
DSC_0361.jpg
loom under tank and top of rear pan cover
DSC_0362.jpg
DSC_0363.jpg
DSC_0364.jpg
You do not have the required permissions to view the files attached to this post.

neilw
Site sponsor
Site sponsor
Posts: 248
Joined: Sat Dec 20, 2008 3:24 am
Bikes: 1995 Roadking(still brand new)
1991 HD springer
1959 pan (I'm reassembling)
Location: Calgary
Been thanked: 2 times

Re: need help tracing my wiring routes.

#4

Post by neilw » Mon Feb 23, 2009 2:01 am

Thanks loads you guys.
Neil

Post Reply

Return to “Electrical”