shift lever change

Post Reply
Dougy
Posts: 6
Joined: Mon Aug 27, 2007 5:15 pm
Bikes: 1958 panhead chopper
Location: Scotland

shift lever change

#1

Post by Dougy » Fri Sep 28, 2007 8:02 pm

I am wanting to move my shift lever, so it is going up rather than down as the bracket on my new pipes is bolted to the hole above the timing inspection hole, and the shift rod will not go down far enough to bolt on to the shift lever so changing the position will let it connect up.Will i have to dissmantal the compleate shift assembly to change the position. If any of you guys has done this some info would be a help thanks Doug



VT

#2

Post by VT » Mon Oct 01, 2007 6:52 pm

Doug, can you draw a pic and post it? Can't follow.

Post Reply

Return to “Transmission, Starter & Shifting”