Thanks for post feature available again: viewtopic.php?f=7&t=17581

Bearing plate springs length

Transmission, clutch, chains and belts
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
haggis
Posts: 177
Joined: Fri Mar 19, 2004 3:35 am
Location: Maine USA

Bearing plate springs length

#1

Post by haggis » Sun Jul 25, 2004 2:15 pm

Anyone know what length these bearing plate springs are supposed to be? took my clutch apart this morning as it was grabbing yesterday...these wee bastards are almost flat!Haggis.



haggis
Posts: 177
Joined: Fri Mar 19, 2004 3:35 am
Location: Maine USA

Re: Bearing plate springs

#2

Post by haggis » Sun Jul 25, 2004 3:36 pm

Aha!....on further inspection..found that the small end of springs (facing out).. where not dressed properly and a little too tight , sometimes they would dig into the the shafts and stay compressed...out with the round file and bingo!...another quality product from Tiawan Tedd. Haggis

Post Reply

Return to “Transmission, Clutch, Belt & Chains”