4 speed tranny mounting plate

Transmission, clutch, chains and belts
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
Posts: 6
Joined: Fri Feb 29, 2008 6:57 pm

4 speed tranny mounting plate


Post by mikemacy » Fri May 30, 2008 5:23 pm

im not sure which way to mount this plate to the frame. does it mount with the cross member across the top or the bottom? also if you are looking at the mounting plate while standing at the rear tire is the cut off corner on the right side or left side?
thanks alot,

Posts: 1827
Joined: Fri May 24, 2002 1:00 am
Bikes: 64FL 99FLHR 01FXSTD
Location: Mpls. MN.


Post by Panacea » Sat May 31, 2008 1:41 am

Cut off corner is on the left, I'm not sure what you mean in regard to the crossmember,The tranny plate mount (back of seatpost) is under the front end of the plate, and of course the rear of the plate sits on top of the two pipe lookin' bosses. Don't forget to check how flat the plate sits on the mounts, especially the fifth mount near the kicker,shim as needed. Mike

Post Reply

Return to “Transmission, Clutch, Belt & Chains”