RevTech 6in4 Tranny

Post Reply
DaveD
Posts: 5
Joined: Sun May 01, 2011 2:36 pm
Bikes: 52 Panhead

RevTech 6in4 Tranny

#1

Post by DaveD » Sat Jun 18, 2011 11:12 pm

I have a late 40's early 50's wishbone rigid frame that I would like to run a 6in4 RevTech Tranny in combination with a Panhead engine..I need advice on the correct parts as well as mods on the chassis to make it work.I plan on using an open belt primary,chain drive on the rear.I notice there is a mainshaft bearing support casted on the case.What does this mount to?My current tranny is a ratchet top 4-speed with an open primary belt. Thank you



Bosheff
Posts: 1234
Joined: Fri Jul 03, 2009 8:23 pm
Bikes: 65 FLH 82 FLH
Location: Michigan
Been thanked: 41 times

Re: RevTech 6in4 Tranny

#2

Post by Bosheff » Sun Jun 19, 2011 3:53 am

Please be more specific when you say mainshaft support cast into the case. Are you in fact talkin bout a trans case with ears and studs as in a 65 and later 4 speed case? I assume you are presently running a 64 and earlier case....bosheff

Post Reply

Return to “Transmission, Starter & Shifting”