dialing in linkert

Linkert related issues
Post Reply
razzle51
Posts: 34
Joined: Wed May 09, 2007 12:07 am
Location: Iowa

dialing in linkert

#1

Post by razzle51 »

i am real close to having this where i want it butttttt,starts good ,idles good ,runs through the gears good. running along bout 65 let off throttle and get back into it it wants to crap somewhat, not pop through the carb, but acts like its loading -up.should i lean up the high side another click or two or the low side. just how much differernce can a click or two make. got home and pulled the plugs, both have a nice tan apperance. just where does the low speed stop and the high speed take over. got the intake tester from mike and yes did have a bad one. replaced both and put on good wrap within clamps, finger tight and then snugged up about 2 turns each. i am open for suggestions please, thanks -dick



Cotten
Posts: 6913
Joined: Mon Aug 26, 2002 9:09 am
Location: Central Illinois
Has thanked: 112 times
Been thanked: 292 times

Re: dialing in linkert

#2

Post by Cotten »

Dick!

If "wrap" means some sort of tape, my suggestion is remove it and clean away any adhesive thoroughly.

Good luck,

....Cotten

razzle51
Posts: 34
Joined: Wed May 09, 2007 12:07 am
Location: Iowa

Re: dialing in linkert

#3

Post by razzle51 »

by wrap around i mean the clamp itself. it wraps within itself like a hose clamp. had the grooved clamps on before and i think it cut the o-ring so i thought i would try these-dick

razzle51
Posts: 34
Joined: Wed May 09, 2007 12:07 am
Location: Iowa

Re: dialing in linkert

#4

Post by razzle51 »

any other suggestions, what else will do this

NightShift
Posts: 532
Joined: Tue Apr 21, 2009 4:20 pm
Bikes: Two Schwinns, a Hercules, and a Hiawatha
Location: Underground in Illinois
Has thanked: 2 times
Been thanked: 3 times

Re: dialing in linkert

#5

Post by NightShift »

Dear Dick,

Did you bubble test after you put it back together? Did you bubble test the pan cover screws above the clamps? Sometimes they get poked into the port.

'Spectful,

razzle51
Posts: 34
Joined: Wed May 09, 2007 12:07 am
Location: Iowa

Re: dialing in linkert

#6

Post by razzle51 »

only does it when i open up the throttle while going down the road. doesn't miss a bit if sitting in driveway and crack the throttle

mbskeam
Posts: 1006
Joined: Tue Mar 16, 2004 5:52 am
Location: Sultan, WASH
Been thanked: 3 times
Contact:

Re: dialing in linkert

#7

Post by mbskeam »

condensor?.....

razzle51
Posts: 34
Joined: Wed May 09, 2007 12:07 am
Location: Iowa

Re: dialing in linkert

#8

Post by razzle51 »

will change and see -thanks

Post Reply

Return to “Linkert”