CONTACT POINT ALIGNMENT

All ignition related articles
Post Reply
amiabledave
Posts: 129
Joined: Tue Sep 28, 2010 2:06 pm
Bikes: 1957 Panhead, First HD was a 1969 Sporster w/factory mag,
Location: Florida
Has thanked: 1 time
Been thanked: 7 times

CONTACT POINT ALIGNMENT

#1

Post by amiabledave » Tue Jan 25, 2011 10:40 pm

HAS ANYONE PUT SHIMS UNDER THE CONTACT POINT LEVER THAT MOUNTS ON THE PIVOT STUD, TO ALIGN EXACTLY TO ITS MATE?

DAVE



mbskeam
Posts: 1006
Joined: Tue Mar 16, 2004 5:52 am
Location: Sultan, WASH
Been thanked: 2 times
Contact:

Re: CONTACT POINT ALIGNMENT

#2

Post by mbskeam » Wed Jan 26, 2011 6:26 am

yes

amiabledave
Posts: 129
Joined: Tue Sep 28, 2010 2:06 pm
Bikes: 1957 Panhead, First HD was a 1969 Sporster w/factory mag,
Location: Florida
Has thanked: 1 time
Been thanked: 7 times

Re: CONTACT POINT ALIGNMENT

#3

Post by amiabledave » Sat Jan 29, 2011 7:21 am

What did you use?

mbskeam
Posts: 1006
Joined: Tue Mar 16, 2004 5:52 am
Location: Sultan, WASH
Been thanked: 2 times
Contact:

Re: CONTACT POINT ALIGNMENT

#4

Post by mbskeam » Sun Jan 30, 2011 1:17 am

a small brass washer...

amiabledave
Posts: 129
Joined: Tue Sep 28, 2010 2:06 pm
Bikes: 1957 Panhead, First HD was a 1969 Sporster w/factory mag,
Location: Florida
Has thanked: 1 time
Been thanked: 7 times

Re: CONTACT POINT ALIGNMENT

#5

Post by amiabledave » Sun Jan 30, 2011 3:40 am

Great...I'll give it a shot

Dave

Post Reply

Return to “Ignition”