:: Panhead and Flathead site ::
Knowledge Base (Archive)
Knowledge Base (Forum Archive)
  General Carburetor Carburetor and Fuel System
- Linkert
- S&S
Electrical System Electrical System
Transmission Transmission, Clutch, Belt and Chain
-
Transmission, Starter & Shifting
- Clutch & Mousetrap
-
Chains & Belts
- Sprockets
Documentation
  Troubleshooting Chassis and Frame Chassis & Frame
-
Fenders, Primary, Tanks & Paint
-
Frame & Fittings
-
Handlebars & Cables
-
Seat
- Speedometer, Dashboard & Instruments
Forks Forks Accessoires Accessories Information
Identification Identification
- VIN / Cases / Heads
-
Frame / Transmission
Wheels and Tires Wheels & Tires Ignition Ignition Parts info
Brakes Brakes Exhaust Exhaust System Motor Motor
- Bottom End, Crankcases
-
Top End, Cylinders, Heads
-
Gear Case, Cams
-
Lubrication System
Members info
 
Specific subjects:
Transmission & Shifting
Clutch & Mousetrap
Chains & Belts
Sprockets
Transmission and Clutch
1965 inner primary gasket
59 oil breather stud ( goes through crank case)
A combination of generator & starter, is there such a thing
Bearing plate springs length
Can't stop primary leak
clutch/cable/shifter/???? problem
compensator gear change
Engine/trans/primary alignment question
for the engine machinists on the forum
Gary Bang seals
Gettin too old, I guess
How are you venting your primary?
Inner primary
inner primary mounting bolt lock ring
Is this a bad idea ???
loose rivets
Mounting 56 Inner Primary Cover
Open Primary options
primairy oiler
Primary case bolts: how are the springloaded bolts installed
Primary chain oiler
Primary chain: a jerk/lunging feeling
Primary oil feed on a primo belt system
Primary swap
Rattlers or no rattlers?
Rocker clutch support
Rocker clutches anyone?
spacers timken bearings
This damn lock ring!!!!
Torque specifications engine sprocket nut and clutch hub nut
trans or clutch
What tool for Sprocket shaft bearing nut removal?

  ^^top^^
Copyright © 2001-2020 Panhead/PTH